In this project damaged sections of sealed pavement across the Mareeba area were milled out utilising a profiler at various depths to a maximum of 300mm dependant on existing.   The greater portion of these sections were replaced with 2.1 gravel and fully sealed with a two coat chip seal and other sections were replaced with asphalt. Drainage structures that were built up with sediment and debris were cleared utilising a combination of jet rodder and vacuum truck.  The full project scope consisted of but was not limited to the following;

• Identification of services and liaison with service providers;
• Traffic management;
• Environmental management;
• Grading of longitudinal drainage;
• Pavement excavation;
• Treating subgrade;
• Supply of pavement material;
• Construction of new pavement;
• Bitumen surfacing to new pavement;
• Replacing road edge guide posts; and
• Reinstating line marking.